As discussed above, there are five levels of momentum that can be programmed into the receiver. They correspond to the letter keys on the transmitter.

A = 5 seconds from zero to maximum speed.

B = 7 seconds.

C = 10 seconds.

D = 15 seconds.

E = 20 seconds.

There is a slide switch on the receiver marked "Linear" and "P.W.C." When the slide switch is on Linear, the above values are cut approximately in half.

To program a new momentum setting, you are also going to reprogram the receiver.

First, program the transmitter for the receiver or block that you want to program. Make sure you have the "Track" switch in the correct position. Then, follow the same two step process outlined above:

Press and Hold Press and Hold the "A" and "B" buttons on the transmitter until the green indicator light on the transmitter begins to blink.

Then Press the button for the block or receiver that you want the transmitter to control.

You are now ready to program the receiver to the desired momentum setting.

First, Press and Hold the "Set" button on the receiver.

While holding the "Set" button, Press and Hold the letter button that corresponds to the desired ramp up rate.

Hold Hold both buttons until the green light on the receiver flashes.

Release Release both buttons.

The green light will now stop flashing.

[ Part 4 ]  [ Part 6 ]

This information was compiled by Dave Freshwater, with input from Matt Schaefer, Dave Greenacre, Gil Brauch, Brian Brendel, John Drye and Jim FitzGerald.